Fine Woodworking

Jigs, Fixtures, Tips & Tricks Archives - Page 2 of 62

Bevel Sled construction and use. Including 5-cut method to calibrate sled.

March 28, 2021

I have used cross cut sleds and miter sleds for many years but never had a bevel cutting sled. Bevel cutting sled does the same job as miter sled. …
Corner Clamp – Precise and Versatile

March 25, 2021

This corner clamp is easy to make with table saw. Wooden wedges clamp the material and keep it square. Four of these clamps, resting on a flat surface, will…
JessEm Table Saw Hold Down

March 21, 2021

I’m interested in getting this for my saw, but every video I’ve seen so far conveniently either omits any clips of actually pushing a narrow piece through the saw, or…
Squaring up boxes with a nail on inside of corner

March 18, 2021

Hi Everyone, I 'm pretty sure I didn't imagine that I heard a reference to the above on a recent Shop Talk Live. Something like taking a board across the…
Accessories for Cross Cut Sleds

March 18, 2021

I've been using crosscut sleds for many years but never bothered with fancy stuff like flip stops. As I had to make new sleds for a new saw, decided to…
Small Cross Cut Sled – Precise and Versatile

March 13, 2021

I made a standard size crosscut sled but found that I was often cutting smaller pieces that would be better suited to a smaller lighter sled. Some features implemented on…
Router Fixture for cutting Juice Groove on a round cutting board

March 6, 2021

Had some difficulty making the juice groove on a round cutting board, until I came up with fixture shown in picture, which uses a router, and two ball bearings to…
Saw Guide Recommendations

March 2, 2021

I can do dovetails, and I've even made a couple of them that I'm proud of. Unfortunately, on any particular project, there's no more than two of the good ones.…
A versatile and precise miter sled

February 26, 2021

My old sleds did not fit on new table saw, so I gave my old sleds to the guy who bought the old saw, and set out to make new…
Micro Adjustment of Table Saw Fence in increments as small as 0.001 inch

February 18, 2021

Moving a table saw fence by very small amounts can be hit and miss. With a dial indicator at the right location on the fence, I found it is easy…

Page 2 of 62 Previous

1
2
3
4
62

Next

Most Popular

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership