Fine Woodworking

Joinery Archives - Page 2 of 289

Is this an acceptable practice on a router table?

July 29, 2021

Hello, I'm making a walnut hall table and it calls for dovetail cuts, that's not a problem, I'm wondering if what they show in the photo will cause kickback. Is…
How to correct a miter

June 22, 2021

I am building a large veneered cabinet. The corners are mitered so grain flows from top to sides. Top is 17” d x 58”w x 1.25” thick. Sides 29” long…
Acceptable miter joint?

June 1, 2021

Hatched area being end grain, will this open up at all? Using 1/2 inch pretty stable stock.Thanks for the replies, appreciate it.
Interior Passage Door

May 25, 2021

I’m building interior, flat-two-panel doors and am debating whether to glue the panels to the rails or not to help with strength. The panels will be plywood so stability in…
Deep? Mortise Work

May 19, 2021

I am struggling to find a reasonable solution to machine mortises in a rail and stile construction glass front door on a cabinet. I’m working on the “Better Built Cabinet”…
Best joint for angled cabinet

April 28, 2021

Hi all,I’m trying to build an angled cabinet underneath my basement stairs. what kind of joinery would you recommend on the angled joints circled in the picture below? Also, would…
Bi-fold doors 4-2-2 meeting edge bevel

April 25, 2021

I have a problematic bi-fold with 4 panels. Two opening left and two right that bind on the meeting edge of the two pairs. This problem is usually solved by…
When to stain drawer fronts with a half blind dovetail

April 19, 2021

I'm building a QSWO bureau using a multi-step finish (Jeff Jewitt's technique). The drawer sides will be ash I plan to keep them blonde. So, when do finish the oak…
Waterfall Kitchen Island

April 14, 2021

Hi,I build tables and islands commercially but newer to the business. People seem to like my style. I didn’t even know I had one! I’m doing a commissioned job which…
Table top with 5/4 10” W boards

April 14, 2021

Hi all,I’m looking to build a table top for a desk. I would like to avoid warping/cupping as much as possible. Is edge joining three 60” L x 9 1/4”…

Page 2 of 289 Previous

1
2
3
4
289

Next

Most Popular

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership