Fine Woodworking

Safety - Page 3 of 13

Tool News: Oneida Air Systems New Deputy Deluxe SD Cyclone Separator Kit

July 18, 2019

From Oneida Air Systems: Oneida Air Systems introduces the newest offering in its Dust Deputy® family of products—the Dust Deputy Deluxe SD Cyclone Separator Kit. This kit combines the patented…
Workshop Tip: Tablesaw Outriggers Let You Use a Smaller Sled

July 4, 2019

MDF panels held in place with rare-earth magnets serve as simple outriggers to support large workpieces when using a smaller crosscut sled.
Workshop Tip: Floor Vise Makes Adze Work Safer and Easier

June 20, 2019

Adapting a tip from Dave Fisher's "Carve a Greenwood Bowl," (FWW #263), a reader uses a clamping jig to secure large bowls on the floor while working with a two-handed…
Tool News: Oneida Air Systems New Supercell Dust Collector to be Unveiled at 2019 AWFS

June 18, 2019

From Oneida Air Systems: Oneida Air Systems, the industry leader in dust collection, will introduce its new compact, high static pressure Supercell™ dust collector at the Association of Woodworking &…
Workshop Tip: Bandsaw Push Stick Waits in the Miter Slot

May 22, 2019

Click here to enlarge. This simple but effective push stick stores in the bandsaw’s miter slot—out of the way yet close at hand. A small rare-earth magnet keeps it from…
Workshop Tip: Tablesaw Shutoff Switch Can Be Accessed In Any Position

December 17, 2018

The pivoting shutoff switch Leon Segal added to his tablesaw is even easier to access than those on commercial models
Workshop Tip: Best push stick is one that’s close at hand

October 25, 2018

Thirty years of teaching woodworking has convinced me that woodworkers will use a push stick consistently—if it’s convenient. If not, they’ll often go without, finishing cuts by squeezing a few…
Jointer Safety: Our Favorite Articles

June 19, 2018

Marc Adams, Asa Christiana, Gary Rogowski, and Fine Woodworking Editors share their jointer safety tips in this roundup of articles and videos, featuring a bonus article on planer safety
STL 165: Staying Safe in the Shop

June 8, 2018

Mike, Tom, and Ben discuss their favorite safety techniques, milling techniques, unfinished projects, and wide miters
Tablesaw Safety: Our Favorite Articles

June 7, 2018

Bob Van Dyke, Steve Latta, Marc Adams, and others share their tablesaw tips in this roundup of videos and articles

No results found.