Discussion Forum

• Refinishing cherry table.

  As a wedding gift to ourselves,  my wife and I had a friend build a mission dinning table.  This table is oval shaped when the two leaves are in.  I…

• Routing diagonals for inlay

  I am inlaying patterns on box lids with radius cutters and router plans but finding difficult to cut diagonals.  I can set up a fence and run a dremel in…

• Dremel router bits

  I’m looking for a source for small router bits.  I’m using a Stewart-McDonald router base attachment on a Dremel to do string inlay.  I need a source for 1/16, 3/32…

• Dust collector filters

  I have a Jet DC-650 dust collector with the felt top bag.  I want to replace this with a 2 or 3 micron pleated filter.  I'm concerned about the seal…

• Dado with Saw Stop

  Using a dado blades with new Saw Stop.Can the over ride feature be turned off to use a dado head without the dado break?

• Where did denatured alcohol to

  I love California, I’m proud the state is comparing climate change.  However, how am I to mix up a batch of shellac without denatured alcohol?  Thanks

• Run out

  I inherited an older model Unisaw.  Is there any hope for it?

• Which table saw less than $2K

  It is time to upgrade my table saw.  I want to keep it below $2k.  I want a cast top, 230V available, 30" fence is okay.Any suggestions?